[Equest-users] CHW error message

[Robby Oylear]

Varkie,

The first screen shot I sent shows where you can manipulate the CHW
setpoint in the DD wizard.  I'm not sure about SD wizard.

On Thu, Dec 15, 2011 at 2:44 PM, Varkie C Thomas <thomasv at iit.edu> wrote:

> Robby: This project is being done by an architect who used DD.  I looked
> for the error in CHW plant and forgot to look at HVAC supply temps.  I was
> mistaken, the Detailed Edit does allow you to set CHWS temp but not SD and
> DD.  Varkie
>
>
> *----- Original Message -----*
>
> *From*: Robby Oylear <robbyoylear at gmail.com>
>
> *Date*: Thursday, December 15, 2011 4:29 pm
>
> *Subject*: Re: RE: [Equest-users] CHW error message
>
> > Whoops, here's the image I meant to send with the detailed edit
> > screen:[image: image.png]
> >
> > On Thu, Dec 15, 2011 at 2:29 PM, Robby Oylear
> > <robbyoylear at gmail.com> wrote:
> >
> > > Varkie,
> > >
> > > On wizard screen 3 of 3 under "CHW Plant Equipment" the setpoint is
> > > defined.  The default is 44 deg F.
> > >
> > > [image: image.png]
> > >
> > > In detailed edit mode this setpoint can be seen on the
> > "Circulation Loop
> > > Properties" screen:
> > > [image: image.png]
> > >
> > > On Thu, Dec 15, 2011 at 2:22 PM, Varkie C Thomas
> > <thomasv at iit.edu> wrote:
> > >
> > >> Kelsey, Robby,
> > >>
> > >> Thanks.  The supply air temp was too low.  What CHWS temp does
> > eQUEST>> assume?  This should be an input value too, besides temp
> > rise.>>
> > >> Varkie
> > >> **
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20111215/0fe48d93/attachment-0002.htm>