[Equest-users] Wizard error.

[R B]

I have had the same error recently - not sure what causes it. But when you
load it again in equest, do a simulation run and then open the wizard. The
error goes away.
-Rohini

2011/7/4 Самолётов Михаил <samoletov.mikhail at bt-comfort.ru>

>  I can`t find  the error. I  have near 20 zones per shell. Then, I divided
> the zone  to 2 different zones. Now, If I load the model, then go to
> Building Creation Wizard, then press FINISH button, the message "An invalid
> argument was encountered" is appeared.  Is anybody had the same error? What
> may be the problem with Wizard? When I load the model in eQUEST there is no
> any message about the problems in model. ****
>
> ** **
>
> Sincerely yours,****
>
> ** **
>
> Mikhail Samoletov****
>
> Chief engineer of****
>
> *"Numerical Simulation Department"*****
>
> * *
>
> *TECHNIQUE BUREAU*****
>
> Cvetochnaya str, 25"Zh", 196084 St.Petersburg, Russia****
>
> www.bt-comfort.ru****
>
> ** **
>
> phone/fax +7 (812) 318-50-30****
>
> mob. +7 (931) 244-83-77****
>
> ** **
>
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to
> EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20110704/bf005841/attachment-0002.htm>