Re: [EnergyPlus_Support] Daylighting calculation

[Linda Lawrie <linda@xxxxxxxxxx>]

At 02:15 AM 11/28/2002, Clemens Felsmann wrote:
>  
> the only daylighting information I have
> to enter are the coordinates of the reference point. But always the
> results seems a little bit strange to me. 
> May be I have to enter entire geometry
> in relative coordinates.

You shouldn't have to do that.  However, if your zone origins would be different in a relative coordinate system, then you do need to enter those as relative in the Zone object.  V1.0.2 will give a warning message when you do.  V1.0.3 will give a similar warning message but note that these are used in the daylighting calculations.

Linda

EnergyPlus WebSite: http://www.energyplus.gov
Owner: EnergyPlus_Support list
Member: EnergyPlus Development Team

Yahoo! Groups Sponsor

ADVERTISEMENT

To unsubscribe from this group, send an email to:
EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/






Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.