[EnergyPlus_Support] Re: Warning messages for running 3zvent.idf

["waspoorboy" <mingsbox@xxxxxxxxxxxxxx>]

Thanks Mike.
For the "orphan objects" warnings in the 3zvent run,
does it indicate that CROSS MIXING and INFILTRATION
are Not used in EnergyPlus whenever COMIS is involved ?
[In other words, if "AIRFLOW MODEL, COMIS;" is stated
in .idf, the CROSS MIXING and INFILTRATION module in
EnergyPlus is turned off ?]
The above also applies to VENTILATION and MIXING objects,
since those four are "grouped", is it correct ?

If WCS is used but zone origin(s) were not (0,0,0),
will EnergyPlus overide the zone origin(s) to (0,0,0)?

Thanks again,
Ming  


--- In EnergyPlus_Support@xxxxxxxxxxxxxxx, "Michael J. Witte" 
<mjwitte@g...> wrote:
> The warnings are just informative and do not reflect any impact on 
> results.
> 
> To get rid of "orphan objects" warnings, just delete the listed 
> objects.  The objects are not used in this simulation and are not 
> needed.
> 
> To get rid of the zone origin warning, set the zone origins to 
> (0,0,0).  Changing to relative coordinates with the current zone 
> origins would alter the geometry of the building.  
> 
> Mike



------------------------ Yahoo! Groups Sponsor ---------------------~-->
Get 128 Bit SSL Encryption!
http://us.click.yahoo.com/xaxhjB/hdqFAA/xGHJAA/dkFolB/TM
---------------------------------------------------------------------~->

To unsubscribe from this group, send an email to:
EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are not allowed -- please post any files to the appropriate folder in the Files are of the Support Web Site.




 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/