[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[EnergyPlus_Support] No energy balance and fixed boundary conditions

Thanks for the replies to the last email  sent to the Forum.

Though I now know how to set the outside wall temperatures I would like to
run EnergyPlus without the zonal energy balance, but with fixed inside and
outside boundary conditions so heat fluxes can be evaluated. Is there a way
to turn-off the zonal energy balance along with all other heating/cooling

Also, I am receiving the following error message every time I open the IDF-

The following invalid slash codes were found in the Energy+.IDD file:

I have not tampered with the Energy+.IDD file at all. Does anyone know why
I am getting this message

Many Thanks

Sope Obadeyi

This email may be confidential, may be legally privileged, and is for the intended recipient only.
Unauthorised access, disclosure, copying, distribution, or reliance on any of it by anyone else is prohibited and may be a criminal offence. 
Please delete if obtained in error and email confirmation to the sender.

------------------------ Yahoo! Groups Sponsor --------------------~--> 
Make a clean sweep of pop-up ads. Yahoo! Companion Toolbar.
Now with Pop-Up Blocker. Get it for free!

The primary EnergyPlus web site is found at:

The group web site is:

Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.
Yahoo! Groups Links

<*> To visit your group on the web, go to:

<*> To unsubscribe from this group, send an email to:

<*> Your use of Yahoo! Groups is subject to: