You can usually report the schedule value based on how the schedule is used.
For example, if the schedule is used to place a set point at a node, use
this in your input file:
Output:Variable,
*, !- Key Value
System Node Setpoint Temp, !- Variable Name
hourly; !- Reporting Frequency
If the schedule is used in the thermostat object:
** Output:Variable,
*, !- Key Value
Zone/Sys Thermostat Heating Setpoint, !- Variable Name
hourly; !- Reporting Frequency
Output:Variable,
*, !- Key Value
Zone/Sys Thermostat Cooling Setpoint, !- Variable Name
hourly; !- Reporting Frequency
Check the rdd file to see what report variables are available for your
simulation.--
le_carambar wrote:
>
>
> Dear E+ users,
>
> The object output:schedules write schedule values in .eio files.
> I would like make appear the value of schedules in csv file.
>
> Somebody have an idea ?
>
> Thanks a lot,
>
> Camille T.
>
>
Richard A. Raustad
Senior Research Engineer
Florida Solar Energy Center
University of Central Florida
1679 Clearlake Road
Cocoa, FL 32922-5703
Phone: (321) 638-1454
Fax: (321) 638-1439 or 1010
Visit our web site at: http://www.fsec.ucf.edu
UCF - From Promise to Prominence: Celebrating 40 Years
__._,_.___
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___