Re: [EnergyPlus_Support] RVI or MVI files?

[Linda Lawrie <linda@xxxxxxxxxxxxxx>]

That well could be true (epmacro).  You should be able
to look at the outputs from epmacro to see.  Or you could send a
.epmdet file (attach it here) and we could look at it.

Also, there is a newer epmacro that I uploaded somewhere.  Macros at
the end of a line (before a ;) were not processed properly.

At 10:00 AM 7/24/2012, Niraj Poudel wrote:

Dr. Zhang has helped me out and suggested that I remove any square brackets in my .imf file definition. For instance I had defined my insulation material as "Insulation [2]" and it looks like that specific square brackets are being recognized as a macro.

Dr. Zhang also suggested that I double check the ##fileprefix line so that it is pointing to the correct folder.

I will give both these recommendations of his a shot. I hope this will be helpful to anyone who is following this thread.

Niraj



On Tue, Jul 24, 2012 at 11:23 AM, Linda Lawrie <linda@xxxxxxxxxxxxxx> wrote:

 

Why not ask Dr Zhang?  As supporter of JE+, he should be able to help?

At 09:14 AM 7/24/2012, Niraj Poudel wrote:

I seem to be having the same problem with the newest version of JE+ or Eplus 7.1. I tried to run an older JE+ parametric run that ran successfully in the past. But when I run it now, using Eplus version 7.1 and JE+ version 1.3. I do not get any results. I am curious to know if Jeremiah has come across this problem as well?

If anyone else has come across this same issue. I would be glad to know how to tackle it.

Niraj

On Tue, Jul 24, 2012 at 10:56 AM, Amirhossein Ghoreishi < amirhosein_ghoreishi@xxxxxxxxx> wrote:

 

So many thanks for all helpful comments. I used the BIOPCM-HC.rvi for jEPlus. The project was validated successfully but after the simulation, the .cvs output file did not contain any information. I also tried the changes Dr. Li had suggested (modifier the .rvi file) but again no results were obtained. Any chance that I am using a wrong .rvi file, which is not compatible with the job I'd like the jE+ to carry out?

--

Niraj Poudel, Architectural Engineer.

PhD student, PDBE Program.

Clemson University, Clemson, SC.

--
Niraj Poudel, Architectural Engineer.
PhD student, PDBE Program.
Clemson University, Clemson, SC.

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___