ÂI was trying to stay inside designBuiler/ energyplus
Â
eQuest has this to say about it:
Â
HEAD-SETPT-CTRL
Takes a code-word that specifies the type of control sequence used for controlling the head set point of the loop circulation pumps.
FIXEDÂ Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â The differential head pressure is controlled to a constant set point, specified as HEAD-SETPT. The location of the differential pressure sensor is HEAD-SENSOR-LOCN.
VALVE-RESETÂ Â Â Â Â Â Â Â Â Â Â Â Â A fixed head set point is not used. Instead the pumps are controlled so that the system head is just enough to provide the required flow to the worst-case coil, with that coil's control valve fully open. In other words, this control sequence monitors the position of the control valves of all coils attached to this loop, and adjusts the head so that the worst-case coil valve is fully open. This minimizes the pump energy wasted through valve throttling. Normally, this control sequence will require a direct-digital control system.
Similar functionality inside energyPlus would work.
Â
Regards Philip
Â
Â
Â
From: EnergyPlus_Support@xxxxxxxxxxxxxxx [mailto:EnergyPlus_Support@xxxxxxxxxxxxxxx]
Sent: December 11, 2014 3:58 PM
To: EnergyPlus_Support@xxxxxxxxxxxxxxx
Subject: Re: [EnergyPlus_Support] Trim and respond pumping logic per Ashrae section 6.5.4.2Â
Â
have you checked if there are existing Modelica Modules which you could tie into e+ over FMU interface?
Â
2014-12-10 23:36 GMT+01:00 pkennedy178@xxxxxxxxx [EnergyPlus_Support] <EnergyPlus_Support@xxxxxxxxxxxxxxx>:
Â
Does anyone have a straight forward method to model the pumping savings attributed to applying a trim and respond algorithm where the pumping differential set point is manipulated until at least one valve in the system is 90% open of greater?
Â
Our current method involves a lengthy process and three pieces of software plus some custom VBA code.
Â
Is this even possible inside energyPlus?
Â
Regards Philip
Â
Â
__._,_.___
Posted by: Jean Marais <jeannieboef@xxxxxxxxx>
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.