Re: [EnergyPlus_Support] Problems with extracting hourly variables from EnergyPlus

On Mon, Sep 30, 2013 at 1:33 PM, Jeremiah Crossett <jcrossett@xxxxxxxxxxxxxxx> wrote:

Joe, I took a look in text editor and Edwin is (of coarse:) correct

Output:Diagnostics, DisplayAdvancedReportVariables;
Jeremiah D. Crossett | Senior Analyst | Phase Change Energy Solutions
120 E. Pritchard St. | Asheboro, NC 27203 | Mobile 503-688-8951

www.phasechange.com
On Mon, Sep 30, 2013 at 11:40 AM, Edwin Lee <leeed2001@xxxxxxxxx> wrote:
I haven't verified, but a quick look in the I/O ref reveals this: Output:Diagnostics,DisplayAdvancedVariables;
On Mon, Sep 30, 2013 at 12:27 PM, Joe Huang <YJHuang@xxxxxxxxxxxxxxxxxxxxxxxx> wrote:
Jeremiah,

I don't use the IDF editor. I just edit the IDF. I've tried adding the following to the IDF

Output:Diagnostics,
DisplayAdvancedReportVariables,
DisplayAdvancedReportVariables;

but it didn't work (assuming that I would see a larger *.rdd). Could you look into one of your IDFs where you've turned this mode on, and see how this command is written?

Thanks.
Joe
Joe Huang
White Box Technologies, Inc.
346 Rheem Blvd., Suite 108D
Moraga CA 94556
yjhuang@xxxxxxxxxxxxxxxxxxxxxxxx
http://weather.whiteboxtechnologies.com for simulation-ready weather data
(o) (925)388-0265
(c) (510)928-2683
"building energy simulations at your fingertips"
On 30/09/2013 11:14 AM, Jeremiah Crossett wrote:

Joe,

You may have to turn on Key 1 DisplayAdvancedReportVariables in the output diagnostics object. (This object is the third from the bottom in IDF editor)

Descriptions of the outputs you are looking for can be found in the input output reference page 210-211 are likely to be one of the following: (bold highlight for the one I think you want)

Surface Inside Face Conduction Heat Transfer Rate [W]

Surface Inside Face Conduction Heat Transfer Rate per Area [W/m2]

Surface Inside Face Conduction Heat Gain Rate [W]

Surface Inside Face Conduction Heat Loss Rate [W]

Surface Outside Face Conduction Heat Transfer Rate [W]

Surface Outside Face Conduction Heat Transfer Rate per Area [W/m2]

Surface Outside Face Conduction Heat Gain Rate [W]

Surface Outside Face Conduction Heat Loss Rate [W]

Surface Average Face Conduction Heat Transfer Rate [W]

Surface Average Face Conduction Heat Transfer Rate per Area [W/m2]

Surface Average Face Conduction Heat Gain Rate [W]

Surface Average Face Conduction Heat Loss Rate [W]

Surface Average Face Conduction Heat Transfer Energy [J]

Surface Heat Storage Rate [W]

Surface Heat Storage Rate per Area [W/m2]

Surface Heat Storage Gain Rate [W]

Surface Heat Storage Loss Rate [W]

Surface Heat Storage Energy [J]
--
Edwin Lee, PhD
Engineer, Commercial Buildings Research Staff

National Renewable Energy Laboratory

Edwin Lee, PhD

Engineer, Commercial Buildings Research Staff

National Renewable Energy Laboratory